In our last working day this year, we release a new Click board. It was fun and a pleasure to release
45 click boards in just 12 months.
IR Click™ is an add-on board in mikroBUS™ form factor. It’s a compact and easy solution for adding
infrared (IR) remote control module to your design. It features TSOP38338 IR receiver module as well
as QEE113 IR emitting diode. The 38 kHz receiver carrier frequency is recommended for RCMM, NEC,
RC5, RC6, r-step and XMP codes. IR Click™ communicates with the target microcontroller via mikroBUS™
UART (Tx and Rx) or AN and PWM lines. Jumpers J2 and J3 enable you to choose between these two ways.
J1 zero-ohm SMD jumper is used to select between 3.3V or 5V power supply. It is soldered in 3.3V position by default.
We invite you to visit the board webpage for more information.
Yours sincerely,
mikroElektronika
