@ Mikroeteam

[Helmut]

A answer was nice, please look at your own posts:

http://www.libstock.com/projects/view/4 ... ck-example

Regards Helmut

[janko.kaljevic]

Hello,

With Dali click we have covered Dali communication protocol.
You should use, for example, development system and Dali click on one side, and Dali ballast chip on other side.
Dali ballast will drive the lamp, and this chip is produced by various companies.
Try searching for appropriate solutions with each ballast chip. Usually they provide necessary documentation.

For example:
http://www.helvar.com/products/luminaire-components

We will provide example for Dali click in other languages and also for PIC and other architectures.

Best regards.

[Helmut]

??
in this PDF page 18 is the High- (9,5V to 22V) and Low-Level (-6,5V to 6,5V) definiert http://www.archenergy.com/lrp/lightingp ... 0V1_13.pdf.

Is the Dali Click-Modul directly connected to a Dali-Ballast? Didn't you have a Powersupply >23V DC?
A sheet is helpfull.
Best regards, Helmut

[janko.kaljevic]

Hello,

Yes you are right. You will need Dali Power Supply in addition to complete Dali system.
We have in plans to provide this part too in near future.

Best regards.