Using the Mikro ICD-Chip with MPLAB

Post your requests and ideas on the future development of mikroC.
Post Reply
Author
Message
bosonics
Posts: 16
Joined: 06 Oct 2010 10:54

Using the Mikro ICD-Chip with MPLAB

#1 Post by bosonics » 01 Feb 2011 23:08

hello,

i bought the easy6 boards. I would like to use the Built-in Mikro ICD Programmer with the MPLAB together.
Witch Programmer should i choose from the MPLAB Menu?
I tried the ICD2 but no Chance, i haven't any Communication!
Why? can you help me please and tell me how i shall setup my MPLAB and the easy6 to resolve the Problem?

Thank you.
Top
User avatar
slavisa.zlatanovic
mikroElektronika team
Posts: 1321
Joined: 07 Apr 2009 09:39

Re: Using the Mikro ICD-Chip with MPLAB

#2 Post by slavisa.zlatanovic » 02 Feb 2011 15:20

Hi!

If you don't have Microchip's programmer/debugger (ICD2, ICD3...) then the only way to use the MPLAB with the EasyPIC6 development board is:

1.)
Generate the hex file in the MPLAB
2.)
Program the MCU embedded at the EasyPIC6 using our mikroProg Suite programming software

On the other hand, if you are in the possession of some Microchip's programming tool, then connect it to the RJ11 connector located at the EasyPIC6 and select it in the MPLAB (Programmer menu).
Best regards
Slavisa
Top
Post Reply

Return to “mikroC Wish List”