for example if I have the following piece of code
Code: Select all
TRISA = 0x00;
PORTA = 0x00;
TRISB = 0x00;
PORTB = 0x00;
Code: Select all
TRISA = 0x00;
TRISB = 0x00; //this line was raised up
PORTA = 0x00;
PORTB = 0x00;
to do this operation I could simply place the cursor anywhere on the third line, press the combination of keys (alt + arrow up). which will move the line up.
in addition another useful operatoin would be the combination of alt + ctrl + arrow up/down which is used to duplicate the same line either up or down.
i think these two operations could be very usefull especially since the majority of coding in assembly would be copy/paste and moving code from one place to another.
now i will go back to my bigPIC board.
Omar.