Touch panel not working on easypic6

General discussion on mikroC.
Post Reply
Author
Message
nnn
Posts: 2
Joined: 22 Feb 2018 11:54

Touch panel not working on easypic6

#1 Post by nnn » 22 Feb 2018 12:02

Hello,

I have problem with the touch panel. It seems that is not reacting at all although I have connected the flat cable to the CN13 connector and turned on SW9.5, SW9.6, SW9.7, SW9.8. Is there anything else I should do in order to make the touch panel working?
Top
User avatar
marko.stankovic
mikroElektronika team
Posts: 108
Joined: 18 Dec 2017 15:44

Re: Touch panel not working on easypic6

#2 Post by marko.stankovic » 26 Feb 2018 09:12

Hi,

Can you tell me about which the touch panel it is?

Best Regards,
Marko Stankovic.
Top
nnn
Posts: 2
Joined: 22 Feb 2018 11:54

Re: Touch panel not working on easypic6

#3 Post by nnn » 26 Feb 2018 11:35

The board is easyPIC6 and the microcontroller I am working with is PIC16F887.
Top
User avatar
marko.stankovic
mikroElektronika team
Posts: 108
Joined: 18 Dec 2017 15:44

Re: Touch panel not working on easypic6

#4 Post by marko.stankovic » 28 Feb 2018 10:01

Hi,

Also, you need to set the calibration.
There exist an example Calibration and Write on Screen in the compiler.
Maybe this help you.

Best Rewards,
Marko Stankovic.
Top
Post Reply

Return to “mikroC General”