hello everybody!
i have a program written by c18 compiler and what i want to do is to write and simulate it by MIKROC
what is the procedure to follow thanks
the program is attached!
code translating!!!!!!!
Re: code translating!!!!!!!
Hi,
Basically, C code is C code whichever compiler you are using.
The only thing that needs to be taken care of are the compiler specifics which can be found in the Help file of the compiler, so I suggest you reading it when doing this.
Regards,
Filip.
Basically, C code is C code whichever compiler you are using.
The only thing that needs to be taken care of are the compiler specifics which can be found in the Help file of the compiler, so I suggest you reading it when doing this.
Regards,
Filip.
Re: code translating!!!!!!!
Thanks for your reply but what i want exactly is not that!!my request is concerning the library and header part usi,g MIKROcfilip wrote:Hi,
Basically, C code is C code whichever compiler you are using.
The only thing that needs to be taken care of are the compiler specifics which can be found in the Help file of the compiler, so I suggest you reading it when doing this.
Regards,
Filip.
and also the instructions syntax
Re: code translating!!!!!!!
This has been done to death elsewhere, it is not easy to translate even the simplest of code from a different compiler to MC because of libraries used in either/both compilers, almost everything depends on libraries and there is no easy transfer mechanism. Many have tried and given up.
Re: code translating!!!!!!!
Hi,
Yes, this can be tricky when it comes to the included libraries, but speaking in general, the code can be translated.
Regards,
Filip.
Yes, this can be tricky when it comes to the included libraries, but speaking in general, the code can be translated.
Regards,
Filip.
Re: code translating!!!!!!!
You try to make this sound so easy and yet it most obviously is not in practice you are not winning any friends here you know.filip wrote:Hi,
Yes, this can be tricky when it comes to the included libraries, but speaking in general, the code can be translated.
Regards,
Filip.
Yes you can translate very simple lines of code but getting anything done that in anyway touches on a library is very very hard.
I agree in general the code could be translated but the effort involved way out-strips the output that you will achieve if you manage to get past the closed source libraries in the first place.