Hi all,
I'm using this pic with mikroc examples and don't work. I sniffed can with canalyzer and do not see anything,
there are any problem library with this pic ?
Can with pic 18F4680
-
- Posts: 177
- Joined: 14 Jan 2007 02:30
- Location: VA, USA
I have also tried using a 4680 several times and I could not get it working properly. When I used the same code with a 4510 it worked as intended.
*edit*
I was not using CAN... it was just basic port manipulation ie: software PWM, LCD, and keypads.
*edit*
I was not using CAN... it was just basic port manipulation ie: software PWM, LCD, and keypads.
"The whole world must learn of our peaceful ways, by force!" - Bender Bending Rodríguez
Re: Can with pic 18F4680
Hi,Buddace wrote:Hi all,
I'm using this pic with mikroc examples and don't work. I sniffed can with canalyzer and do not see anything,
there are any problem library with this pic ?
i'm know also using a PIC18F4680 and want to get it working with mikroC
Did you succeed then in your mission?
Gr
- tihomir.losic
- mikroElektronika team
- Posts: 2138
- Joined: 02 Dec 2009 14:16
- Location: Serbia
- Contact:
Re: Can with pic 18F4680
Hello,
you can look for our examples on following link:
http://www.mikroe.com/eng/products/view ... spi-board/
Examples provided with this board will show you how to connect the MCP2551 CAN transceiver to an MCU easily.
Best regards,
Losic Tihomir
you can look for our examples on following link:
http://www.mikroe.com/eng/products/view ... spi-board/
Examples provided with this board will show you how to connect the MCP2551 CAN transceiver to an MCU easily.
Best regards,
Losic Tihomir
mikroElektronika [Support team]