Now I want to connect the ferroelectric FRAM 2 click through mikroBUS, and then connect mikroBUS to the STM32H7xx board through the Arduino REV3 interface. I don’t know if anyone has relevant experience and does not use mikroSDK, because mikroSDK does not support my board very well. seem.
The only thing I am confused about is, whether I can only manipulate the SPI through the HAL of the STM32 to read and write the corresponding interface. Because I understand that if the pins of each module are connected correctly, then the signal I send to the SPI pin of STM32 will eventually be transmitted to the SPI pin of FRAM to achieve reading and writing.
Or because I have a mikroBUS as a bridge in the middle, the bridge module and the FRAM module must be initialized?
Hope for an
answer!!!!!!
