UART 2 issue on EasyPIC Pro v7

[divivoma]

Hello All,

First of all I describe my hw:

-EasyPIC pro v7 with the standard micro sold with the dev board
- I saw that the micro pcb has a 16MHz quartz

I've tried the example code of the UART 2 (with RS 232 not via USB) but I read wrong characters.

I've already set up the DIP switch properly in order to set only UART 2 and not 1.

Is there any changes to do in the project config?

Thank you for any comments.

Marco

[p.erasmus]

If your board has a 16 Mhz Crystal then you should set the OSC frequency to 16 000000 not 8 000000 as in your config