Hello,
I Have some issues downloading the program to the MMB sometimes it works and sometimes not,but an error has occurred
with ICD 3 programmer it was working properly and suddenly the following error showed up :
ICD3Err0035: Failed to get Device ID. If you experience
persistent problems communicating, the ICD 3 test interface
can be used to help diagnose the problem.
What can I do to solve this problem asap and thank you.
Urgent.. MMB for PIC32MX7 ISSUE.....
- tihomir.losic
- mikroElektronika team
- Posts: 2138
- Joined: 02 Dec 2009 14:16
- Location: Serbia
- Contact:
Re: Urgent.. MMB for PIC32MX7 ISSUE.....
Hello,
first of all, I need to apologize to you, somehow that topic slipped out from Support eyes.
Secondly, can you tell me does this message appear again?
Best regards,
Losic Tihomir
first of all, I need to apologize to you, somehow that topic slipped out from Support eyes.
Secondly, can you tell me does this message appear again?
Best regards,
Losic Tihomir
mikroElektronika [Support team]
Re: Urgent.. MMB for PIC32MX7 ISSUE.....
Thank you ,
Actually it appears every time and all the time.
I have another pic32mx7 I have tried it only once and its okay using the same steps for the damaged one, but again I have tried it only once because am afraid that the same issue will happen to it again.
Actually it appears every time and all the time.
I have another pic32mx7 I have tried it only once and its okay using the same steps for the damaged one, but again I have tried it only once because am afraid that the same issue will happen to it again.
- tihomir.losic
- mikroElektronika team
- Posts: 2138
- Joined: 02 Dec 2009 14:16
- Location: Serbia
- Contact:
Re: Urgent.. MMB for PIC32MX7 ISSUE.....
Hello,
unfortunately, this is kind of hardware issue.
Please, contact me on my personal e-mail:
tihomir.losic@mikroe.com
in order to find solution for your board.
Best regards,
Losic Tihomir
unfortunately, this is kind of hardware issue.
Please, contact me on my personal e-mail:
tihomir.losic@mikroe.com
in order to find solution for your board.
Best regards,
Losic Tihomir
mikroElektronika [Support team]