EasyPIC V7 and PIC18F26K42

[abhijitrashinkar]

Hello!

Kindly excuse if i have made a mistake to post in wrong section.

I am using EasyPIC V7 development board and trying to program a PIC18F26K42 chip but unfortunately without success, i receive a warning "Device detected: Unknown ! MCU selected PIC18F26K42, Continue anyway?", i double checked all the connections all well, i tried to read/write 18F26K22 (to validate), it works perfect, the version for MikroProg Suit for PIC is V2.80

Can someone shed some light where am i going wrong.

Thank you.

Abhi

[abhijitrashinkar]

Hello!

is the chip not supported by this board or programming software?

Abhi

[filip]

Hi,

Please update download the latest mikroProg Suite for PIC and update the EasyPIC7 firmware, then you will be able to program K42 family of MCUs.

Regards,
Filip.

[abhijitrashinkar]

Hello! Filip
good afternoon

May i request you to share the link for the mikroProg Suite for PIC and the EasyPIC7 firmware, i tried to search on the website but honestly did not find or may be i am doing something wrong, for your knowledge i am using Version 2.80 for mikroProg Suite, and my development board is EasyPIC V7.

Thank you, hear you soon.

Abhi

[filip]

Hi,

Here is the link to the latest version of mikroProg Suite :
https://download.mikroe.com/setups/prog ... p-v290.zip

The tutorial on upgrading firmware is here :
https://download.mikroe.com/documents/p ... pgrade.pdf

Regards,
Filip.