INT CLOCK FREQUENCY CHANGED

[DEBABRATA GHOSH]

Hi everybody,
I am a electronic hobbyist and doing some experiment on PIC 12F629/675. I am new to PIC.
I started with the INTERNAL CLOCK of around 4MHz, factory set, for my experiment
In my experiment Clock FREQUENCY is not very important.
My question is that if I change the frequency to 3,2 or 1 Mhz by the software ( Micro C pro / MPLab )
will that damage the controller?
With lowering the frequency circuit is working fine according to my need.

Thanks
D.Ghosh

[filip]

Hi,

By changing the frequency you will not damage the MCU, maybe it wouldn't run properly until you set the proper frequency.

Regards,
Filip.

[DEBABRATA GHOSH]

Thank you Filip

Regards,
D.Ghosh :