v6.2.0: problem attaching the "tools" toolbar.

[Dany]

Hi,
In de latest version of the IDE (v5.70) there is a problem with attaching the "tools" toolbar to other toolbars on top of the screen.
I can make the tools toolbar visible (is shown somewhere in the middle of the screen), drag it to the toolbars on top, attacht it there (it seems), save the layout, but nevertheless: after IDE restart it does not show, or it shows somewhere else than attached to the other toolbars.

Something changed there also with respect to v5.60? (there it was ok).

Thanks in advance!

[Dany]

Work around from mE: see http://www.mikroe.com/forum/viewtopic.p ... 75&start=2.
Thanks!

[Dany]

The problem is still there in version 6.2.0...

[Aleksandar.Mitrovic]

Hi Dany,

I was not able to reproduce the same behavior.
Can you please attach screen shot of your compiler?

Best regards,
Aleksandar

[Dany]

I was not able to reproduce the same behavior.
Can you please attach screen shot of your compiler?

Hi Aleksandar, thanks for the reply.
The problem is of course already solved (by copying the docking.ini file from an older installation into the new one), so I can not show any more the IDE with the problem.
I did see the problem after installing the latest version of the compiler (I suddenly saw I worked with an older version).
I must say, everything in the IDE seemed normal, I could pop up the tools toolbar, put it on the top of the screen with the other toolbars, save the layout, and everything worked fine until after mP was closed and restarted.
After restart the tools toolbar was gone again.
I tried a few times to install it again with the same result.

[Aleksandar.Mitrovic]

Hi Dany,

I tried once again to reproduce the same behavior and I manage.

I notice that only "Tool toolbar" is not saved after reset.

Thank you for reporting this. I will report this behavior to my Development team.

Best regards,
Aleksandar