mikroProg Suite warning (Ok)

Beta Testing discussion on mikroPascal PRO for dsPIC30/33 and PIC24.
Post Reply
Author
Message
Dany
Posts: 3854
Joined: 18 Jun 2008 11:43
Location: Nieuwpoort, Belgium
Contact:
Contact Dany

mikroProg Suite warning (Ok)

#1 Post by Dany » 03 Jun 2011 11:58

Hi, how can I get rid of an mikroProg suite warning like this (I tried all mikroProg suite options, I use the lv24-33 programmer.):

Image

It happens when I interrupt the power supply of the PIC (P24FJ64GA002) between programming sessions.
I do this to restart the PIC from scrap. The PIC is fed out of the programmer through the programmer's 10fold connector.

Thanks in advance! :D
Last edited by Dany on 29 Jul 2011 13:21, edited 2 times in total.
Kind regards, Dany.
Forget your perfect offering. There is a crack in everything, that's how the light gets in... (L. Cohen)
Remember when we were young? We shone like the sun. (David Gilmour)
Top
Dany
Posts: 3854
Joined: 18 Jun 2008 11:43
Location: Nieuwpoort, Belgium
Contact:
Contact Dany

Re: mikroProg Suite warning

#2 Post by Dany » 09 Jun 2011 10:57

Hi, I was able to make the warning disappear by changing something to to my prototype board: I placed an elco of 1000uF between the ICD10 connector's pins GND and MCUVCC/VCC.
Doing this the voltage on the 3.3 output of the programmer drops very little when I switch off/on my prototype circuit, and the brown out detection is not happening any longer.

Many thanks! :D
Kind regards, Dany.
Forget your perfect offering. There is a crack in everything, that's how the light gets in... (L. Cohen)
Remember when we were young? We shone like the sun. (David Gilmour)
Top
Post Reply

Return to “mikroPascal PRO for dsPIC30/33 and PIC24 Beta Testing”