The GUI of Interrupt assistant of mikroC for dsPIC v5.40 is not behaving properly (see picture) and is unusable. The problem occurs on fresh install of Win7 x64 SP1.
I also installed mikroC for PIC32 v2.1.0 for comparison. No problem there.
Problem with Interrupt assistant GUI
Problem with Interrupt assistant GUI
- Attachments
-
- Interrupt assistant is behaving properly.
- mikroC PRO for PIC32 v2.1.0.jpg (181.45 KiB) Viewed 4195 times
-
- Interrupt assitant GUI is not misbehaving.
- mikroC PRO for dsPIC v5.40.jpg (195.51 KiB) Viewed 4195 times
Re: Problem with Interrupt assistant GUI
Hi,
Thank for your report, we will fix it as soon as possible.
Regards,
Filip.
Thank for your report, we will fix it as soon as possible.
Regards,
Filip.
Re: Problem with Interrupt assistant GUI
Filip,
I recently installed the new version of MikroC Pro for dsPIC and have just noted the interrupt assistant tool does not appear to have installed. Can you direct me where to get the exe file.
> Ignore - it now seems to come up. Not sure what was going on, but each time I clicked on Tools/Interrupt assistant, the tool did not load. Now suddenly it works.
Thanks
PS. Tried to delete this post once I realized the problem was resolved, but could not see a way to do it (only see options to - preview, submit, cancel - when editing a post?).
I recently installed the new version of MikroC Pro for dsPIC and have just noted the interrupt assistant tool does not appear to have installed. Can you direct me where to get the exe file.
> Ignore - it now seems to come up. Not sure what was going on, but each time I clicked on Tools/Interrupt assistant, the tool did not load. Now suddenly it works.
Thanks
PS. Tried to delete this post once I realized the problem was resolved, but could not see a way to do it (only see options to - preview, submit, cancel - when editing a post?).
