- -- Code folding feature in Code Editor
-- MIDI support
-- I2c slave mode
-- Symbols visible from modules
-- Overloading routines
-- Bit variable + bit operations
-- Build utility (compile all units in project)
-- Possibility to rotate fonts on GLCD
-- Support for 16F505
-- Smart card library
-- Support for 10Fxxx PICs
-- DTMF library
-- BANKSEL command for assembly
-- Table with common register setup for most used chips.
-- ORG directive to work with library routines
-- Regular (slower) mode for I2C
-- PS2_Write routine
-- Selection ident with TAB key (Editor)
-- Indicators in IDE for compiled/programmed project
-- File transfer in terminal tool
-- Recompile if needed during simulation
-- Option to switch off animated menus- sets as default in windows
-- Editor: TAB as spaces
-- Sound routine
-- PORT.Variable = ...
-- USB routines
-- Pulse_In/Out routine (done as sound routine)
-- Show procedures stack depth in Statistics
-- Programming chips from IDE
-- Software protocols: uart, spi, i2c
-- Flexibile LCD configuration
-- Driver for 8-bit LCD
-- 5ms delay in LCD library is not needed
-- FAT16 read file function
-- Floating point support
-- LCD_Out to write at current position
-- User defined tools
-- IRDA driver+example
-- Reading and writing program flash
-- BMP editor for graphic LCD
-- Variable delays
-- Constant declarations with constant expressions
-- Comments in assembly
-- Auto save option in IDE
-- Inverted soft_uart output
Can't wait....