The problem has been resolved. I had to use the last toolchain for Eclipse.

I have done an experiment. I taken off MCU card from BIGAVR2 and checked states through my logic probe on port F. There is not any regural states( no logic 0 and no logic 1 so state is something between).Conclusion is that this is not fault because of bad configuration BIGAVR2. Mega128 is broken eit...

I have sent your adjusted code to mega128 but port F still not flashing. I am attaching my hex code for you to check it.

I have BIGAVR2 board with mega128 MCU card. I wrote very simple code flashing leds on ports. Ports PA to PE working fine (I can see flashing leds) but port PF does not work(leds not flashiing). Fuses for JTAG and M103 compatibility mode are off. Microswitch SW1 for all ports are on, jumpers J18,19 a...

Problem has been resolved. Mega128 has separate ISP interface on diffrent pins.

I have BIGAVR2 development board. For some reason I can not use built in programmer and want to use USBASP programmer. Then I connected my USBASP programmer directly to MCU board (mega128 by soldered wires) to appropriate pins. Unfortunately my software does not recognize microprocessor. Programmer ...

Thaks. That resolved my trouble.

Since I have changed my operating system for windows 7 my programmer on my development board BIGAVR2 does not work. In Windows XP was fine. I have downloaded the last driver and avrflash but still does not work. The message i receive is "I can not communicate with hardware".

I have started to use Windows 7 (32 bit) . My problem is I can not use built in programmer on my BIGAVR2 . When i use it i get error " I can not communicate with hardware". It does not work with any drivers either for XP(32bit) or Vista(32bit). Do you have any solution.

Use Library Manager in your mikroBasic IDE to do this.

The problem is I do not have library manager in my IDE. The question is why.

I have been trying to change standart glcd image for my own but I am not able to do that. I have looked into forum for solution , found few topics but still i don't understand the idea and can't do that. And this is my code '* Project name: ' graphical LCD test '* Author: ' MikroElektronika, Septemb...

I have been trying play with glcd and touch screen. I have found article on mikroelektronika website with attached code so I tryed this code but my compilator showing me faults all the time. This is reference code and I completly do not understand why these faults appear . Under part of code cut of....