hi, I have applied the configuration in two examples and it does not work. Indicates an error in __lib_delays.c however if I change the clock value of 150Mhz to 120 or 64 and the compilation is ok, but the example doesn't work. Compiling at 120 Mhz , the debugger goes to assembler Ethernet_Demo.lst ...

The example Project named Ethernet_Demo (Ethernet Library demo for internal Ethernet module) cannot be compiled on NectoStudio, at 150Mhz and compiled at 72Mhz or 120Mhz does not work. Is it possible to change the setup of the clock to make it work? ,so that MCO has 50 MHz for the PHY IC. I would ap...

I have a Fusion for ARM V8 board, and I'm developing using STM32F407ZG on Windows 10
Open Package Manager 'Barometer 6 click'
Necto Build OK
Necto Flash OK
Debug always stop in line 63
variable dev_id in line 60 = 255
Would need to configure something?

Error Codegrip on Fusion for ARM V8, Connecting to device failed .
Solution (in this case):
MCU options:
1.- Change setting Connection =Under reset and Halt on connect = Enabled.
2.- Power Off/On on Fusion Arm V8
3.- Target is detected.

Thanks filip for your repply.
Attached board.
I changed another MCU STM32F407 and not find the device.
Regards

CodeGrip can not find the device STM32 on Fusion for ARM v8 board.
Attached settings in CodeGrip and SW2 on Fusion board.