Search found 6 matches
- 04 Dec 2020 07:16
- Forum: Development Boards
- Topic: DWM1000 UWB Click Board on Flip&Click - problem communicating via SPI
- Replies: 1
- Views: 628
DWM1000 UWB Click Board on Flip&Click - problem communicating via SPI
I have a UWB Click board on a Flip&Click Dev board (ATSAM3X8E). I'm programming it in Atmel Studio 7, so I had to fudge the libraries a bit. I'm adapting the driver from DecaWave. I'm just trying to read register 0, which should return 0xDECA0130. Using a logic analyzer, as far as I can tell everyth...
- 23 Nov 2020 05:30
- Forum: Additional Software
- Topic: Using other compilers.
- Replies: 2
- Views: 1756
Using other compilers.
Another question: Can the libraries in Libstock only be used with Mikroe compilers? Otherwise, how do I link to them? What the heck is a mpkg file and how do I unpack it?
- 23 Nov 2020 04:59
- Forum: Additional Software
- Topic: MikroSDK and Atmel/Microchip Studio 7
- Replies: 1
- Views: 2199
MikroSDK and Atmel/Microchip Studio 7
Has anyone tried to make MikroSDK work with Studio 7? I'm trying to follow the porting instructions, but it would help if I had an example.
- 17 Nov 2020 04:34
- Forum: Development Boards
- Topic: Flip&Click U2 and UART -
- Replies: 1
- Views: 640
Flip&Click U2 and UART -
Does U2 on the Flip&Click function as a serial port when not being used to program the chip? If I use the UART, will it connect as a serial link like an FTDI chip?
- 28 Oct 2020 01:28
- Forum: Website & Forums General Discussion
- Topic: Flip&Click SAM3X question
- Replies: 2
- Views: 1696
Re: Flip&Click SAM3X question
"Can you please clarify your question"
That was it. Just wanted to make sure that I didn't have to avoid or do anything in particular.
Thanks much.
Paul
That was it. Just wanted to make sure that I didn't have to avoid or do anything in particular.
Thanks much.
Paul
- 26 Oct 2020 00:28
- Forum: Website & Forums General Discussion
- Topic: Flip&Click SAM3X question
- Replies: 2
- Views: 1696
Flip&Click SAM3X question
The Flip&Click SAM3X has an ATMega on it (U2) that I presume is the Arduino interface/programmer. Is there a way to use this to load other software (e.g. .hex files generated by a compiler) onto the ATSAM, so that I don't have to go through the programming header? Alternatively, if I do program the ...