Hi,

Ok, but one the Speakup click there is no reason of having an output. It's a card made to hear what you say.

Thank you for your feed back,
Sébastien

Hi,

Can someone explain me which is the utility of the "line out pads" on the Speakup click. Is it to connect an external microphone?

Thanks,
Sébastien Thiry

Hello everybody,

Is someone can tell me which current can flow through the IO in standalone mode? I want to control relay and that will control a motor. But can I directly control power relay?

Thanks,
Sébastien

Hello, I want to make a Raspberry pi 3 and a GPS2 click to communicate with i2c, so I have moved jumpers, and enabled i2c on raspberry pi. So on Raspberry Pi, I execute i2cdetect -y 1 and the GPS should appear at address 0x60 and 0x62, but I get this pi@raspberrypi:~ $ i2cdetect -y 1 0 1 2 3 4 5 6 7...

Oooh OH OH it works,

Thank you so much, I was searching about this problem for some days now

Sébastien

Hello and thank you so much for replying. Yes my MCU operate at 3.3V but I don't really understand what you mean by: "you would need to supply the 5V pin on the Click board with an external power supply of 5V." Ok my SMD jumper is on 3.3V since my GSM module power supply is 3.3. Do you mean I have t...

Hello guys, I'm trying for some weeks to get GSM2 click working, I'm trying with an Omega2 but I think this is not a problem since I have successfully get GPS2 click working with it. So, on this page https://www.mikroe.com/gsm-2-click , to turn on the gsm module, you have to bring pwk to up state (3...