Dear Petar,

Please send zip file which is working fine

Thanks
Sharfudeen

Dear Petar,

Thanks for your reply
Still same even changed the parameter as you said above

Thanks
Sharfudeen

Dear Petar,

Any update for the above?

Thanks
Sharfudeen

Dear Petar,
Thanks, I will wait for your reply after investigation
Thanks
Sharfudeen

Dear Petar, I have tried with different code to write. Please find attached the Project code. In this code, write the data 0x00 to 0x79 increment 1 writing address, high - 0x00 and low - 0x00 to 0x79. After writing, read the data from the above address. I have read different data. 00 85 8C 13 50 FC ...

Dear mikroElektronika team, I am facing the problem to write data into serial EEPROM 24LC512 with using PIC32MZ2048ECH144 PIM https://www.mikroe.com/easypic-fusion-v7-pic32mz2048efh144 It reads existing data which is already stored in EEPROM. That means it has not write new data. I have attached the...

Hi,
I have a same problem what you asked the above.
Did you solve the problem?
If yes, please share to me
Thanks
Sharfudeen

Hi Hexreader,
Thanks for your reply.
The delay in the code 1 second. LED output should be one second OFF and one Second ON.
But real output is two seconds OFF and two seconds ON.
Thanks
Sharfudeen

Hi,
I have purchased MCU Board PIC32MZ2048EFH144. I wrote simple program for LED blinking in 1000ms delay.
But LED is blinking 2000ms delay.
I have attached Project Zip file and capture of configuration from Edit Project.
Please correct it, if i made wrong in the configuration.
Thanks
Sharfudeen

I am using EasyPIC Fusion V7, PIC32MX795F12L MCU card.
I never received Hello message at all.
I used UDP Terminal.

Dear Peter, Thanks for your reply. Please find attached my project. This project is a testing the UDP transmission, once initiated the udp transmission by send any characters, PIC send "UDP Transmition" text, further on whenever press the push button, PIC should send "Hello" Message. This is for mon...

Hi, I have faced the problem to send UDP data to PC from PIC32MX795F512L without request from PC. I wrote simple program 1. Ethernet_doPacket() while loop, whenever send any data from UDP Terminal, PIC send "UDP Transmition" Text. It is working perfectly. 2. I used one switch which is connected to P...