Thank you petar sir.

I followed your instructions.
but still find following error.

Dear sir,
Thank you for response.

can u upload error pic?

which version proteus?
This error shown by proteus not compiler, right?
can u upload your proteus schematic?

Dear sir, i have been purchased mikromedia-4-pic32mx7. i downloaded mikromedia-4-pic32mx7-examples-v100 from website. i m using mikroc pro for pic32 version4.0.0. i m unable to compile this example. get lots of error msg regarding fat32 ,ethernet etc. i also try to add library but still not solved. ...

please check jumper setting J1, J2,J8,J9.


Is it correct for pic 16? PGD and PGC at RB7 and RB6 for pic 16...

i m using on mikro c pic32 , working on tft

when i use floattostr and display on tft , its not working correctly.
when float value is 0.010 then it display 1 .2^e.
but it should be display as feed value 0.010 or 0.01

Hi I m using pic 32mx795l512 with micro c. I want interface with sn74hc165 . Everything working fine unless I connected data pin to G12. I can read data line on Multimeter . It's working. When I connect data line -pin 9 at pin G12 data line voltage down from 3.3 volt 0.95 volt So pic consider as low...

i m working on TFT with pic32mx795l512 using mikroc pro pic32 (mikromedia plus pic32mx board). i m using timer2_3 for every 60 sec interrupt. everything working fine until timer2_3 interrupt generate. after that touch sense is not working. following is interrupt routine, others code i bypassed. time...

Thank you filip

i m trying to place label caption 175.65 on the button but its hide below it.

Thank u dusan
u r always be there for help.

i did same way, what should i do for to print 1.00?
whenever float value zero after decimal, like 1.00 it print 1 only.

1) what is difference between box click on and button click on ? both working on same pattern?

2)i create one label then one button , when i place label on button ,label get hide . how to send button back side of label?

i m using mikroc pro for pic32 version 4.0.0.. i m trying to use FloatToStr_FixLen. but i couldn't find this in any library. i checked all libraries. any specific way to use this instruction? i want to use float variable with specific decimal point. like float temp =312.5689 i want to display this v...

Thank you Dusan