tanks
yes but i dont find any example

bye
Dario

good morning
i am using micromedia arm (stm 4).
I'm looking for ways to play WMA sound.
MP3 sound is ok but I don't understand how to configure
for WMA.
I downloaded the vs1053 data sheet but it is not clear.
any of you managed to play WMA files ??

thanks to anyone who can help me
Darione

hi
my hardware key (dongle) is to version 5.4

but more problem , the example for mikromedia is lot of error.
(see picture )

with explanations MIKROE it is not clear how to plan.
the examples don't work .... boooo.
what is it for?

bye
Darione

hi my version mikrobasic is 4.5.2 your example is loaded in mikrobasic ...... But not run only white screen appear. not running in basic and not running in TFT :( :( boooo you use old compiler? the example downloaded from mikroelektronica site works well but new project not running. new project work...

hi Stefan thank you very much I, perhaps, understood the problem the problem could be the calibration of the touch panel if ,in visual TFT, I use TP manual calibration nothing works if, in visual TFT, I use TP PRESET calibration it works well why? i use mikrobasic compiler (you have example in mikro...

hi I bought visual tft v.4.6 I have tried the examples that are there, they work well I tried to make a new project with visual TFT no new projects work, tft works but touch panel doesn't work I calibrate by touching the corners the panel has 320x240 points I followed the instructions on the interne...

Hello everyone I would like to use CAN BUS mini M4 with interrupt.(PIN 8-9) Now I use a loop to read if data arrived (do - loop like mikroe example ) I don't know how to activate receive interrupts. Possibly? Does anyone know how to do? I use Mikrobasic, but an example in other languages is fine. Th...

good morning

Petar, 1000 thanks, mikroprog now work perfect.

darione

Hello does not work, in mikroprog, read, write verify, etc., etc. only processor programming works.(i use win 7 pro) If I press "detect MCU" does not work and says he does not find interface. this happened when I installed mikroC.(last release) how can I do ?, can someone share version 1.31? thank you

find solution
wrong declararion CAN1InitializeAdvanced
now work

darione

hi I installed microprog 1.60 and new driver a bad idea ... old microprog worked better every moment tells me old Firmware (see Picture) if I answer yes, I go to the ST site. But you can not do anything maybe better to buy st programmer? put away mikroe programmer? (st programmer is not expansive , ...

hallo I still have the problem with can-bus communication when I transmit data with port p89 in canbus mode I built a small card with st32f415, with Driver sn65hvd232. but still the data does not exit from the can bus. must it be the recessive bit present? every time I write on the bus the processor...

Hello Filippo
thanks for reply, I have solved.
I had the MMC statement wrong

now it works well.

thanks
Darione

hallo! I connected a mini sd card to the mini-M4 kit (stm32f415) I connected PC8-9-10-11-12 pin from stm32f415 to the sd Card all pin have a pull up. I use the Fat_32 library downloaded from here.... but but when the program enters the INIT function it stops and it does not come out anymore. I also ...

but found thi doc. on the Texas instr. site the problem is not the driver 11.3.1.3 Interoperability of 3.3-V CAN in 5-V CAN Systems The 3.3 V supplied SN65HVD23x family of CAN transceivers are fully compatible with 5 V CAN transceivers. The differential output voltage is the same, the recessive comm...