sonnyk wrote:Nice How do you control it? do you also use a free channel for this? [EDIT] Ooh, I can see now that you don't have a spare port for control Very similar to my gizmo
Hi Sonnyk,
not at this time - later i want to implement a control via RC to switch
some functions.
...What I meant with the led's in the earlier post was that you could make a "led bar" that is visible from the ground, that shows the values you want to see, like acc level and so on. My "RC light" controller is based on an 12F629 or similar and drives the leds without any amplifier. Very few comp...
...Some considerations, your idea on sending telemetry data back to you is nice, but have in mind that is NOT easy to take your eyes from a RC heli when flying to look on a small display, you just don't have the time to do it. Hi sonnyk, yes you're right - it's only time for a very short look when ...
I found a program called "I Button", MkC\Examples\Easy5\ExtraExamples\Button Dallas\P16\16F877\IButton ... and it deals with the serial IDs ...Alain Hi Alain, thank you for your suggestions, but when i have to do it with the DS18x20 with more than one devices on 1-Wire, reading there ROM-ID's and u...
Thanks a lot Dany, yes i think that will be the right way. I want to use 2 or more DS1820 devices in my Helicopter, to display onto my remote control the temperature of the 2 or more engines (motors) in it when i fly with him - perhaps later also for one tail rotor engine. I want to have only the fo...
i use MikroC routines "Onewire" and works well in BigPic5 board for a 8MHz crystal.
Hi SPONTEX,
your speed of your used crystal is not important. The return-code of the
DS-1820 is digital so there can't be any mistake for that - or, your ds-1820
isn't ok.
It would be nice if the RST line could be ignored and tied to Vcc. Hi, so that will be an option, i'm not sure if the GLCD need RST line...i believe that you have to test it in practice. :lol: An possible alternate to 18F2550 is the MCU PIC18F4550 as a DIP40 or PLCC44 (if available) - if you need s...
Hi I have some 18F2550 pics and I want to do a project with a 128x64 glcd. Hi ringram2077, sorry, i don't know which ports are available in your project. I think It will be possible when you use PORTB complete for your GLCD data bus (d0...d7), and use the rest of PORTA (0..5) to handle the control ...
Hi all, i use the mikroC example for driving UART (receive only). With the standard settings at 8Mhz it will be working perfectly with :shock: : - 16F877A - 18F452 but the same code won't be run with 18F4550 and 18F4685. :( At the moment, i use the settings as like as here: http://www.mikroe.com/for...
Reciever/transimmiter must not affected by others recievers/trasmmiters of course. If you have any ideas, just write it here, thank you very much :) Hi wh1sp3r, a very easy and also cheap ( transmitter/receiver module ~10,- EUR) solution is to use it with 433.92 Mhz modules, with a ready Library of...
...Maybe I missed something. I am using the PIC18F4550. Don't have a completed schematic yet. Hi Bill, i believe at first that a specified datasheet of 18F4550 will help you soon whats going on with hardware using from your used MCU... 8) Perhaps, for a PIC 18F4550 you have many take into account, ...