I appreciate your helping out. I did not get any errors when uploading the commands or when loading the program. Everything loaded fine. I will try setting other pins tomorrow as it is now 9:00 pm for me. Thanks

After recording my command, it played it back for me automatically. My first commands were "lights on" The word length was set for two seconds. The second set was set to a word length of 2 seconds as well but this time I just said "lights" and had the I/O pin set to toggle instead of to on. Still th...

I get no voltage what so ever. I even set it up so that when I first open the program, the pin is already set to high. And the LED is on. However when I set it to low and speak the command, it does not light. Thank you for your response.

When setting my commands, I do not see any place where I can set the duration. Can anyone help me with this please? Thank you

I set up my speakup board. I recorded the commands and am using it as standalone. I hooked up an LED to my bread board with a 220 ohm resistor in front of it. I assigned I/O pin 1 for the output and connected the ground from my module to the breadboard. When I speak lights on, my LED does not light....