Understood, thank you!
Considering these, unfortunately Necto it's not an option for me... at least for the time being.

Hi, At the time, Necto Studio supports only CODEGRIP programmers/debuggers, mikroProgs should be supported in Necto in the upcoming updates. Kind regards, Thank you for your answer. Can you give me an idea if we are talking about nearest future or just about future? :D I'm asking as I was tented to...

Hello, Just installed Necto trial on a Linux machine... looks great! However I cannot load a trivial code on a PIC18LF47K42 on an EasyPIC v7 board. My assumption was that I should select my board on "Programmer&Debugger / ChooseTargetBoard:" list... that's not possible, nothing appears here. So my f...

Thank you very much Jovana, you were right, an update of the programmer's firmware from mikroProg Suite fixed the problem.
Cheers!

Thank you for your answer, hexreader. I downloaded v2.8, installed it but the result is the same. :( I'm trying the exactly same setup on two different 47K42 uCs and one 47K22... compiled code it's a main() function with a NOP inside As you can see on attached images, programming works for K22 and f...

Hello, I'm trying to use a PIC18F47K42 on an EasyPIC v7 board. The code was compiled with mikroC v7.2 (I'm aware about the fixes on v7.3 beta) and the programmer uses MikroProgSuite v2.70 (47K42 appears on both). However I got the attached error. So the question is: can I use EasyPIC v7 with PIC18F...

Ah, I see... u r right, thank you.
Maybe something like a "note" should be added near this PIC (and maybe others...) on EasyPIC "Supported Devices" section of board's manual.

Hi, Just bought the development board and the MikroC Compiler for PIC, Anniversary Edition. I successfully wrote and tested an old project using a PIC16F684 (14DIP). However, I cannot write or even read a PIC16LF1455 with exactly the same jumper positions (J1, 2, 8, 9, 19) except J5 which is on 3V3 ...