never mind. I found the issue!

I'm getting this error (see above) when I try to start the debugger. Note that I am able to download to the board using the programmer. There must be a configuration bit I'm not setting correctly.
What causes this error when using the debugger even if the programmer works?
Any ideas?

I'm working on a project that combines the air sensor click and the eink display. The development system is the kinetis clicker 2 board. I'd have to disagree with you about the screen updates. The effect of writing text on the display is very noticable. There must be some way of updating the screen ...

I'm trying to display some parameters on an Eink display. The problem is that the entire screen blanks between screen updates. For example in the following code, the screen refreshes 8 times. If there a way to cache updates then refresh the screen once when all the fields have been updated? while( 1...

I couldnt get this to work. Eventually I was able to locate the package .c and .h files which I copied into the project. I know that this is cheating but I dont have unlimited time to spend on the problem.

I'm trying to use the library for the kinetis processor using the air quality 2 click. I've installed the package for the click but the entry doesnt show up in the library window. When the package was installed it created an entry for mk64 (kinetis) so that I'm not sure what I'm missing.

Thank you!

Is there a document that defines how to assign pin numbers for the kinetis processor? Here is the piece of code I'm struggling with: sbit EINK_C_CS at PTD_PDOR.B4; sbit EINK_C_RST at PTB_PDOR.B19; sbit EINK_C_DC at GPIOC_ODR.C2; sbit EINK_C_BSY at GPIOB_IDR.B8; the markings on the pcb for these pins...

I'm definitly confused also. I'm going to pursue a different course.

I'm using the air quality click which seems fine. I'm just not sure how to program the HID device.

Also to answer your question, I am able to program the board using the MikroProg device.

The example program communicates using the UART library. Can this be converted to use the HID?

I've tried rebooting, installing the drivers and reinstalling the microprog software without any luck. I'm using Kenetis version. The com port just wont appear on the device manager screen. help!

The dongle appears on my old laptop in the printers and devices window. However, ir doesnt appear on my new laptop.

where do I download the hid drivers for windows 8.1?