after call to the library function ADC_Read, I read out the ADRESH and ADRESL bytes, and the effect is also there. Is that enough for any conclusion?

I did not investigate further, as it worked as I described. I could give it a try, if you have some easy to use hints how to accomplish

o.k. got it. Is really strange. Here are some reads from the ADC: 0000000011111101 0000000101010110 0000000110101110 0011111000001011 0011111001100111 0011111011000001 0011111101011111 Only the right 10 bits are valid from the ADC. Why there are 1's on the left side mixed in? I guess a bug in the PI...

I have a strange problem. Some time ago I set up a steering wheel interface with an 12F675, see https://forum.mikroe.com/viewtopic.php?f=147&t=64697 Years later I changed the radio to a more modern one, but now would need a PWM module, to interface that new radio. as the 12F675 misses PWM I picked t...

Dear Robert, thanks a lot for your explanations. I willl further think in that way with a doubled input to two pins. I think the switch input type is somehow fixed, as the resistor network of the steering wheel is fixed. I think I generate a voltage between 3.6 and 4.35 V and will use that as a refe...

Hello there, I established an steering wheel interface for my car radio with an 12f675. The voltage of the resistor network is read everey 25 ms, and the respecting command is sent to the radio remote input. This is working so far quite good, except that "short" pushes on the button are not seen by ...

ahem ... my currently installed version is 5.8

Thanks for your hints!

When I want to install the upgrade, it is recommended to uninstall the previous version.

Is there a way to save the configuration, as I spent some effort to get the prefered look and feel of the editor and the flashing options...

Thank you!

Hi all, this was an easy one: There are so much jumpers on the board... and one was connecting the variable resistance with the mentioned pin....

Thanks for your patience...

Regards

Hello to all, I'm new to the PIC world and Mikroelektronika. I want to use the P12F629 with the EasyPic4 board. The PIC should read digital input High from GP2 and others and do some actions on the remaining pins. Everything works fine, except reading the input from GP2. The board is configures: - L...