HI I WILL BRING MY CAMERA IN TOMMORROW AND TAKE A PIC OR TWO THE MESSAGE I GET IN MIKROPROGSUITE BELOW THE CONFIG STUFF UNDER TYPE = UNKNOWN IT DOES NOT RECOGNISE THE PIC I HAVE LOOKED AT YOUR SUGGESTED MANUALS AND HAVE CONNECTED THE LV24-33 CORRECTLY MY VOLTAGE IS 3.3V ON THE PIC I HAVE DECOUPLING ...

it works when i use the real ice and mplab then i have no problems ,my mikroelektronika
usb programmer works when i use the pic16ga004 the error says not a lvflash device.
does it matter which row on the usb programmer i use to connect the target device to ?

yes i am using mikroProgSuite 2.25

yes mikroBasic PROfor dsPIC v5.7.0 also why do you have 2 rows of the
same pinout on the usb in system programmer with icd.

mcu vcc - board vcc
mcu rb6 - rb6
mcu rb7 - rb7
mcumclr - mclr
gnd - gnd

hi i have programmed a 24f32ga004 with the usb programmer i received with the lv24-33 development kit this is using icsp, but i cannot get the 24f16ka102 to program i get messages like this "device currently selected is not {lvpicflasdh prog} driver is usb18f firmware v1.20 with latest updated versi...