Ok I figured it out. Got the firmware updated and now it supports a lot more devices. Thanks MikroE.

OK so doing a little research I found that my board HW version is 1.16.12.21 and the firmware version is 2.11 is the the current version of firmware?

Hello,
I was wondering of the new easypic7 development boards that are sold today have updated firmware compaired to the first gen easypic 7 boards? and if so is thare a way to update the firmware to accomodate new devices?

I updated MikroProgSuite to 2.90 and now I get the same message.IF I revert back to MikroProgSuite 2.80 then I can connect.

Ok So I updated MikroProgSuite to 2.90 and not My EP7 won't connect. The Link LED is on and the Red USB symbol on the MikroProgSuite is Active,but I get a "Not connected to Development Board Message"

Hello I am using EP7 and the device is 18F2620. I am loading the hex file to program the device and mikroProg shows the wrong fuses. I am using a third party compiler not a ME compiler. It should not make a difference anyway. Thanks for any advice on this issue.

Can you please download mikroProg Suite for PIC v2.90 and update the firmware for mikroProg

does this apply to Easypic7 and where can it be downloaded from? Thanks.

I am unable to login the the help desk also.

This did not work. I changed my password and I still can't log in.

Hello everyone,

I am trying to login to Lib Stock using my forum login and password and I am unable able to do so. It says invalid username or password. can someone help me on this? Thanks.

Charlie Moore

Hello everyone, I was wanting some ideas of how to create some software to control the ignition timing of a small gas engine. What I have so far is I am using a 16f877a and input capture to prototype the software and then I plan to port it over to a 12F683 pic. The static timing is 30 degrees before...

Hi Thanks. everything is working fine now.

Ok I have narrowed it down to a compatibility issue. anyone else seen this?

Hello Everyone, I am getting a warning message" Development Tool not detected Make sure development is connected" when trying to program a pic. I see the USB symbol in the PicProg window is red and changes to grayed out when I turn off the easypic7. Can someone advice me on what to do next? I am run...

Hi Marina,

Never mind. I tried it today and it is working. I don't know what I did, but all is ok. Thanks.