Hi,

I want to know the range of SmartGPS development Board in metres or feet.

regards
kawal

Hello Filip Sir,,

yes the program worked but pinging gets disturbed in that also..


Regards
Kawal

Hii Sir,,

Development Board is our In-house and for ethernet we are using ENC28J60 system.


Regards
Kawal

Hello Filip Sir,

Yes The original SPi_Ethernet library works but it pinging goes out of order after some time.

please suggest something.

Regards
Kawal

Hi,

I had also worked on RS485 Protocol , but i had not used any library function...If we think then there is not relation between timer 0 and RS485 working, You better check your program coding your program is hanging somewhere..

Hi I am working on thos new Network Ethernet library..But getting some problems please help me mikroe team

pLz Mikroe team help me to get rid of this problem

Hi Mqamar,

Sorry, but i dont have much knowledge about webpages on EnC28J60..I cant suggest you anything.

Regards
Kawal

plz help

Hi p.erasmus

Ok sorry for this.

My code is below: My problem is The moment I send request from OPC Server to Communication board it stops pinging and communication stops.. plz help //ext Xystal=20Mhz .RS232 is connected to UART2 ,HMI is connected to UART1 //Internal Xystal=16Mhz #define _MODBUS_TCP_REQ_LENGTH 12 #define _REQUEST_...

Hii, I had implemented Modbus TCP and MOdbus Serial in my project... My project working is like this... A PC (Master ) sends Request to Pic18F65K22( Communication Board) via Ethernet implemented on ENC28J60 and Communication Board responds back. Request is basically reading or writing Registers on S...

For EXT OSC, snap shot setting for EDIT PROJECT is shown

Pll working with Internal Oscillator at 16Mhz. Snapshot Shows the EDIT PROJECT settings. In the Snap shot at OSCILLATOR FREQUENCY FIELD ...fill the freq at which internal Oscillator is working. PLL working with external Oscillator at 20Mhz. Snapshot Shows the EDIT PROJECT settings. In the Snap shot...

I want to know one thing;
When Pll is enabled it multiplies the operating frequency by a factor of 4.
This frequency with PLL enabled = (Crystal freq /4 ) *4

If Crystal freq= 20Mhz
frequency with PLL enabled = (20 /4 ) *4 = 5 * 4 = 20 Mhz.

Am i right..Plz reply


Regards
Kawal