sorry flip, could you give me more precise information, helpdesk things, how do i open a ticket?

https://i.ibb.co/fMDHnqX/Screenshot-15.png https://i.ibb.co/gSNvNwd/Screenshot-16.png https://i.ibb.co/cLNVzSy/Screenshot-17.png https://i.ibb.co/K0cPWRw/Screenshot-18.png immagini gif tumblr hi flip thanks for the availability, but as you can see the problem persists, I have the vague doubt that w...

https://i.ibb.co/fNYXqJZ/Screenshot-8.png https://i.ibb.co/8DpfbXm/Screenshot-9.png https://i.ibb.co/kmGQTVg/Screenshot-10.png https://i.ibb.co/Pg0t7Ng/Screenshot-11.png https://i.ibb.co/YTtNfNF/Screenshot-12.png https://i.ibb.co/qD88wcw/Screenshot-13.png https://i.ibb.co/Qp5wqyD/Screenshot-14.png ...

as you can see from the photos, the wifi license has disappeared, if I try to insert it it tells me that it has already been registered, while the wifi parameters does not accept them it always says operation failed. if instead I install the 13.1 firmware together with the 13.1 software then it work...

https://ibb.co/bvvQzZG
https://ibb.co/6w5K7V3
https://ibb.co/x3D9v7Z
https://ibb.co/HqJN5Ld
https://ibb.co/F8HM4x9
https://ibb.co/kx2mkxj
https://ibb.co/KmkPfzS

hi flip, I upgraded the suite to 14.2 as required by the software, and the firmware instead is 14.1

reloading codegrip I discovered that when I put the license, it gives me a message registrtion code already approved

hi to the forum, I have an easypic v8, and I am using mplab as ide, the problem that arose, and that mplab requires me the software codegrip 14.2 and firmware 14.1, now I update the firmware quietly, but I can no longer connect it wifi, the license is in my possession, and checking the update had ca...

okay thanks anyway, in the end reading on other sections I discovered that it is a common problem and you have to proceed with the firmware downgrade

hi and good evening, I ask for the support of the community for an error that happens when I try to program my easy pic v8, let me explain, last week I updated both software and firmware codegrips, and so far everything is fine, the problem and arose later, peche from that moment on mikroc if I try ...

hi flip, i tried to debug, but it doesn't give me errors. any other suggestions?

@support mikroe, why did my post go into oblivion, without even being worthy of a little reply?

no one can give me answers?

good evening, some good Samaritan, can you help me?

hi to the whole forum, I'm trying to make more interrupts work at the same time, the problem is that in my case the ioc interrupts work well, in fact a wiegand26 reader is connected to them and it reads me the tags in complete tranquility. the error arises instead with the timers that are necessary ...