MikroElektronika Forum

I've been unable to connect to my board.

Mikromedia for Pic32
Windows 10 (I've only used this on windows 7 previously)
Latest Mikrobootloader (2.7.0.0)

Tried:
Restarting computer
All usb ports.
Run as administrator
Keep MikroC closed (this was a problem for me before)

Mikrobootloader never reconizes that the MCU is connected.
I need to make this work for a contract job I'm doing asap.
Thanks

Hi,

I'm sorry for the inconvenience.

Can you please submit a ticket regarding this issue at support[at]mikroe[dot]com,
and write when does the problem start to occur, did you use programmer?

Best regards,
Lana

I have the same issue, this post has any solution?
I opened the ticket ID: FUJ-718-98084

I'm trying to use the MikroBootloader in a MMB PIC32MX7 card (Link: http://www.mikroe.com/multimedia/pic32mx7/) but I do not recognize the USB card. The card is working properly, try on several USB ports and turning it off and restarting the card but nothing. There is a compatibility issue of SW? What I can do?
Im using Windows 8 64 bits and mikroBootloader USB HID v2.10 and mikroBootloader USB HID v2.40

Thanks

Hi metalpic,

Welcome to the MikroE forum.

I have answered you on the ticket,
so I suggest you to continue our correspondence there.

Best regards,
Lana

lana.arsic wrote:Hi metalpic,

Welcome to the MikroE forum.

I have answered you on the ticket,
so I suggest you to continue our correspondence there.

Best regards,
Lana

Again I also have an issue with windows 10.... HID bootloader is fine with Window7...

Why don't you post the answer here for all to see... Then we don't need to duplicate tickets!!!

Hi,

Unfortunately, we haven't reproduced the issue
with mikroBootloader version 2.7.0.0 and Windows 10, and it was tested many times.

My colleague has responded you on the ticket,
so you can continue your conversation there.

Kind regards,
Lana