MikroElektronika Forum

Excuse me friends, I know that this forum is not for the pic basic pro language, I just wanted to ask if someone has programmed in pic basic pro, better known as PBP.
Thank you
Jose Luis

Used it 10 years ago.
Made a couple of 500-700 line projects.
I don't remember what I didn't like about it, but I switched to Micro Basics and I still use it:)

thank you very much for answering, you know I made a code in pbp with pic 16f877a, in the proteus simulation with a 20x2 lcd the negative and positive voltages are recorded, but these remain blinking and do not remain fixed, and I also want to migrate this code to it works in pic 16f887.
I send you this link so you can see the video of the simulation in proteus with the 20x4 lcd you will see that the voltages blink and do not stay fixed.
could you help me please
https://drive.google.com/file/d/19zVIgp ... DTNa4/view

Thank you

PROTEUS is good, but I debug without it.
The old fashioned way, step by step.
Drop the source code in your personal message.

Do you want me to post the code here? Or did I send you the code by internal message?
thanks for replying again

A personal letter is better.

I sent you 2 messages to staff and private.
In both messages I shared all the information, and I hope you can help me and thank you

Hi there!

Did you manage to pass your project?

Hi there!

Did you manage to pass your project?

hello friend, I inform you that I approved the project at the university and it was all thanks to you friend.
I'll write you from hotmail,
Jose Luis

Hello, I recently received help from the user PV31, I appreciate your help initially and I improved the pic basic pro (pbp) code a bit, symmetrical source code.
But I reduced the code to 54 programming lines and it uses pic 16f877a and lm358 operational amplifier in inverter mode.
attached image