UART_Remappable_Init in PIC18F26J50
Posted: 08 Mar 2010 04:45
Hi,
In my project I am trying to use SPI and UART at the same time, for that, I need to use UART2. In MikoC exists only the library UART_Remappable, and I want to know how to configure the UART?
When I use the UART_Remappable_Init (57600), I have the error message "Too many actual parameters" How can I set the Baud Rate for 57600?
Any surgestions please
Ivo Bernardo
In my project I am trying to use SPI and UART at the same time, for that, I need to use UART2. In MikoC exists only the library UART_Remappable, and I want to know how to configure the UART?
When I use the UART_Remappable_Init (57600), I have the error message "Too many actual parameters" How can I set the Baud Rate for 57600?
Any surgestions please
Ivo Bernardo