My whish ...
Posted: 19 Jul 2011 15:19
1. ... support for the ATMEL JTAGICE3 / MK2 / AVRISP MK1/2 STK500/600
Yes we can use them by setting up a Tool with Keyb. shortcut, BUT then you should implement that the messages from the tools readable in your Message Window.
When starting a STK600.exe for programming the .HEX file the window disappears so fast that no one can see if any error occurs.
JTAGICE3 is important for the XMEGA PDI programming.
2. Codegenerator for settings and Interrupts.
A few clicks and we have setting up the PORTs I/O, the Interrupts, the ADC and the lot of other little things we write from Hand every time we start a new project.
3. The Helpfiles should contain more information with XMEGA / samples
By the way : I have never seen so nice Helpfiles before !
Last wish : Excuse my bad english
Greetings from Germany
Yes we can use them by setting up a Tool with Keyb. shortcut, BUT then you should implement that the messages from the tools readable in your Message Window.
When starting a STK600.exe for programming the .HEX file the window disappears so fast that no one can see if any error occurs.
JTAGICE3 is important for the XMEGA PDI programming.
2. Codegenerator for settings and Interrupts.
A few clicks and we have setting up the PORTs I/O, the Interrupts, the ADC and the lot of other little things we write from Hand every time we start a new project.
3. The Helpfiles should contain more information with XMEGA / samples
By the way : I have never seen so nice Helpfiles before !
Last wish : Excuse my bad english
Greetings from Germany