MikroMedia 5 for PIC32MZ Not visible in Codegrip
Posted: 24 Jul 2023 16:41
Hello!
I am a new user of the Mikromedia5 for PIC32MZ Capacative board (https://www.mikroe.com/mikromedia-5-for ... capacitive).
My board did not come with a switch installed on SW1. There are indents on SW1's pads, so I think the switch may have broken off in manufacturing or transit. As a workaround, I have shorted SW1 to the ON position.
I have connected the board's USB C port to a SS USB port on my laptop. The board's PWD led turns green and the "Mikroe Color Selector" application appears on the screen.
As well, when I plug the board into my laptop, windows plays the "device plugged in" sound. Sometimes when I plug the board in, windows says it is initializing a USB device, and then tells me that the HID Bootloader is ready to use.
However, when I scan for devices in CODEGRIP, no devices show up. Further, scanning in CODEGRIP causes Windows to play the "USB device disconnecting" sound.
My Fusion for PIC32 V8 board shows up in CODEGRIP, no problems.
Relevant software & versions:
Board: Mikromedia5 for PIC32MZ Capactive
OS: Windows 10
Codegrip Suite: 1.6.3 (latest)
Any advice is much appreciated!
Thank you!
I am a new user of the Mikromedia5 for PIC32MZ Capacative board (https://www.mikroe.com/mikromedia-5-for ... capacitive).
My board did not come with a switch installed on SW1. There are indents on SW1's pads, so I think the switch may have broken off in manufacturing or transit. As a workaround, I have shorted SW1 to the ON position.
I have connected the board's USB C port to a SS USB port on my laptop. The board's PWD led turns green and the "Mikroe Color Selector" application appears on the screen.
As well, when I plug the board into my laptop, windows plays the "device plugged in" sound. Sometimes when I plug the board in, windows says it is initializing a USB device, and then tells me that the HID Bootloader is ready to use.
However, when I scan for devices in CODEGRIP, no devices show up. Further, scanning in CODEGRIP causes Windows to play the "USB device disconnecting" sound.
My Fusion for PIC32 V8 board shows up in CODEGRIP, no problems.
Relevant software & versions:
Board: Mikromedia5 for PIC32MZ Capactive
OS: Windows 10
Codegrip Suite: 1.6.3 (latest)
Any advice is much appreciated!
Thank you!