NECTO and Mini-M4 STM32
Posted: 18 Oct 2022 12:57
I just downloaded NECTO Studio (2.2.0) and tried to build my first project using the Mini-M4 STM32, but that board is not listed under "boards". I tried "generic ARM", but I'm not sure of the internals of the board to do a hardware setup. I purchased 3 Mini-M4 STM32 boards 2 years ago for $20 each, and now they are $79 and they are not supported? Why not?
How do I get the hardware set up for the STM32F415RE? I see an external 16 MHz Xtal, but what are all those "settings" that are not listed since the board is not supported? I cant even get on first base without any "settings".
And then there is the programmer. It wont scan and find ANY boards, not even a Nucleo-64 with a STM32F401 on COM22. I got it to that point with the Mini-M4 STM32 and it would not find that board, which is understandable since it is not supported.
How do I get the hardware set up for the STM32F415RE? I see an external 16 MHz Xtal, but what are all those "settings" that are not listed since the board is not supported? I cant even get on first base without any "settings".
And then there is the programmer. It wont scan and find ANY boards, not even a Nucleo-64 with a STM32F401 on COM22. I got it to that point with the Mini-M4 STM32 and it would not find that board, which is understandable since it is not supported.