STM32H743ZI - Scheme file description do not match
Posted: 23 May 2019 11:50
Hi,
i have a problem with mikroC for ARM v6.2.0.
I would like to create a new project (STM32H743ZI), but if i edit the general project settings, click "OK" and open the settings again,
9 settings are lost.
PLL1 DIVP division factor, PLL1 DIVQ division factor, PLL1 DIVR division factor,
PLL2 DIVP division factor, PLL2 DIVQ division factor, PLL2 DIVR division factor,
PLL3 DIVP division factor, PLL3 DIVQ division factor, PLL3 DIVR division factor
If i save the settings in a "Scheme" and reload it again, an error message appears. (See attachement)
I would be glad, if this error is eliminated as soon as possible.
King regards
_Chriss_
i have a problem with mikroC for ARM v6.2.0.
I would like to create a new project (STM32H743ZI), but if i edit the general project settings, click "OK" and open the settings again,
9 settings are lost.
PLL1 DIVP division factor, PLL1 DIVQ division factor, PLL1 DIVR division factor,
PLL2 DIVP division factor, PLL2 DIVQ division factor, PLL2 DIVR division factor,
PLL3 DIVP division factor, PLL3 DIVQ division factor, PLL3 DIVR division factor
If i save the settings in a "Scheme" and reload it again, an error message appears. (See attachement)
I would be glad, if this error is eliminated as soon as possible.
King regards
_Chriss_