Problem with delay statement in Necto studio
Posted: 27 Apr 2022 20:51
Hi,
I am transferring a program from PICPROC, which runs fine. When I transfer the code to Necto, I get various problems with the program hanging. Using the debugger it would seem the program is hanging on a delay statement. If I remove the delay statement, the program will run. After further development of the program, the issue may return at a different delay statement.
Sorry if this is a bit vague, but I don't really understand what is going on.
Any help, comments or suggestions would be appreciated.
Ian
I am transferring a program from PICPROC, which runs fine. When I transfer the code to Necto, I get various problems with the program hanging. Using the debugger it would seem the program is hanging on a delay statement. If I remove the delay statement, the program will run. After further development of the program, the issue may return at a different delay statement.
Sorry if this is a bit vague, but I don't really understand what is going on.
Any help, comments or suggestions would be appreciated.
Ian