SOLVED-Problem with uploading .hex files to mikromedia XMEGA
Posted: 04 Mar 2018 11:58
I have mikromedia for XMEGA, microcontroller ATXMEGA128A1.
It was everything ok until today, with uploading .hex files, and mikromedia worked fine with executting programmes, official examples and with my code.
Now, I have problem with executting programme after uploading, using mikroBootloader. When I start mikroBootloader, I connect properly and I have confirmation in mikroBootloader with Conn "light". After that, without problem I can choose .hex file and start uploading. Uploading of .hex file it is done without problem, and I "receive" message that uploading is finished and recommendation to restart MCU.
When I restart MCU, nothing happend, I have only "white screen". It also happened when I turn off and turn on mikromedia.
I uploaded some of my .hex files, and after that I tried with your official examples, and result is same.
I searched forum, but I did not find anything similar, so I decide to write new post.
Any idea what can be a problem?
It was everything ok until today, with uploading .hex files, and mikromedia worked fine with executting programmes, official examples and with my code.
Now, I have problem with executting programme after uploading, using mikroBootloader. When I start mikroBootloader, I connect properly and I have confirmation in mikroBootloader with Conn "light". After that, without problem I can choose .hex file and start uploading. Uploading of .hex file it is done without problem, and I "receive" message that uploading is finished and recommendation to restart MCU.
When I restart MCU, nothing happend, I have only "white screen". It also happened when I turn off and turn on mikromedia.
I uploaded some of my .hex files, and after that I tried with your official examples, and result is same.
I searched forum, but I did not find anything similar, so I decide to write new post.
Any idea what can be a problem?