Beaglebone mikroBus Cape: EEPROM
Posted: 26 May 2020 09:25
Hello,
I just received the mikroBus Cape for Beaglebone Black. I recognised that the I²C EEPROM on this board is a Microchip 24AA01I.
Looking into the datasheet, it says that this device ignores the address selection input pins.
I double checked this information by running an I²C scanner. The EEPROM will be showing at addresses 0x50 - 0x57. This confirms
the information from the datasheet, but is different to the information in the manual for the mikroBUS cape.
Please correct this information or choose a different EEPROM.
with best regards
Frank
I just received the mikroBus Cape for Beaglebone Black. I recognised that the I²C EEPROM on this board is a Microchip 24AA01I.
Looking into the datasheet, it says that this device ignores the address selection input pins.
I double checked this information by running an I²C scanner. The EEPROM will be showing at addresses 0x50 - 0x57. This confirms
the information from the datasheet, but is different to the information in the manual for the mikroBUS cape.
Please correct this information or choose a different EEPROM.
with best regards
Frank