Serial data out of Uart
Posted: 16 Jan 2015 01:14
Hi,
Firstly I just received my Speakup and I like it alot.
My aim is to use it by sending Index codes to a Raspberry PI via wireless but to get things tested first I have wired the UART (Mikrobus) TX,RX and GND to a Serial to USB converter on a PC and have a Terminal program running on the PC.
When the Speakup boots up I get a "Ready" on the terminal screen .
I test the speakup with a word I have recorded and I know it has recognised it as the red LED stays on longer but no Index code is sent to the terminal.
I have set the notify master to UART and the baud rate is right as I get the "ready"
Any ideas
Cheers
Sean
Firstly I just received my Speakup and I like it alot.
My aim is to use it by sending Index codes to a Raspberry PI via wireless but to get things tested first I have wired the UART (Mikrobus) TX,RX and GND to a Serial to USB converter on a PC and have a Terminal program running on the PC.
When the Speakup boots up I get a "Ready" on the terminal screen .
I test the speakup with a word I have recorded and I know it has recognised it as the red LED stays on longer but no Index code is sent to the terminal.
I have set the notify master to UART and the baud rate is right as I get the "ready"
Any ideas
Cheers
Sean