MikroElektronika Forum

Hello,

i am trying to initiliaze the 7x10 r click on EK-TM4C1294XL with Code Compose Studio in order to display numbers & chars.
How can do it? the Libray in libsotck describes only a schema and ist not exactly for the code compse studio !

Every information is welcome.

With regards !

Ozzy

Dear Ozzy,

at the moment I am struggeling with the same problem.

I am too working with the 7x10 R Click on EK-TM4C1294XL and Code Composer Studio.

If you found a solution and could share this, then I would be very grateful.

Thank you in advance.

Best regards
M.