MikroElektronika Forum

Hi,

I have a board easyPIC v7 that works with my "old computer" so the easyPIC v7 is 100% OK

with the new computer - asus - I get the message " Mikro Prog Firmware v2.11 - driver unavailable

I already erased and reloaded/installed/restarted computer with the latest issue of MikroC and associated MikroProg drivers
the amber light led "Link" does not burn

windows repair kit confirms: missing drivers

What can I do ?

Thanks for your help - Bernard

Hi,

please do the following procedure:

1. Uninstall previous drivers.
2. Disable UAC(User Account Control Settings in Control Panel)
3. Restart your computer
4. Install the driver as administrator. That means Right click on the icon -> Run as administrator

Also uninstall mikroProg suite and install it as admin as well.

Do you have any windows language packs installed?

Regards,

Danilo

Dear mikroElektronika team,
I've a problem that it is not detected the EasyPIC v7 development board by mikroprog suite programmer. I try the best with your suggestion post by reinstalling the software and test again and again. I found that it is not driver error. When I connect the board, the warning message is appeared. Pls, see the below.

download/file.php?mode=view&id=20697
and then I check show Device that shows on the tab of the mikroprog suite programmer. USB programmer device is empty. See the picture as follow.

download/file.php?mode=view&id=20698

I can’t also update firmware.

I try the another EasyPIC v7 board, it is Ok and running. I found the USB programmer Device when I check it.

download/file.php?mode=view&id=20699

So, I would like to know, is it device error? How can I solve it.
Looking forward for your suggestions.

Hi,

Follow the instructions in the attached video. Regards,

Ivan.

Hello, Ivan
I try the next time according to your video. It is Ok. The mikroprog is firmware updated and worked correctly.
Thank a lot for your supports.
Danieltha