Problems with mikroProg for STM32
Posted: 22 Dec 2012 15:14
Hello all,
I try to connect my mikroProg for STM32 to an MCU-Board from my univerity.
This MCU-Board has an IDC10 JTAG Connector with the pinout from the mikroprog for STM32.
After connecting the MCU-Board and pressing the 'detect MCU' button nothing happens!?
After pressing the 'Reset' Button the red LED and the blue LED on the mikroprog light short and thats it.
On the board there is a STM32F103C8T6 MCU.
Has anyone a tip why this mcu was not identified?
Thanks for answers.
Regards
CS
I try to connect my mikroProg for STM32 to an MCU-Board from my univerity.
This MCU-Board has an IDC10 JTAG Connector with the pinout from the mikroprog for STM32.
After connecting the MCU-Board and pressing the 'detect MCU' button nothing happens!?
After pressing the 'Reset' Button the red LED and the blue LED on the mikroprog light short and thats it.
On the board there is a STM32F103C8T6 MCU.
Has anyone a tip why this mcu was not identified?
Thanks for answers.
Regards
CS