Problems with mikroProg for STM32

General discussion on mikroProg™ programmer and debugger and mikroProg Suite software as well.
Post Reply
Author
Message
CS
Posts: 357
Joined: 20 Dec 2005 23:30
Location: Germany

Problems with mikroProg for STM32

#1 Post by CS » 22 Dec 2012 15:14

Hello all,

I try to connect my mikroProg for STM32 to an MCU-Board from my univerity.

This MCU-Board has an IDC10 JTAG Connector with the pinout from the mikroprog for STM32.

After connecting the MCU-Board and pressing the 'detect MCU' button nothing happens!?

After pressing the 'Reset' Button the red LED and the blue LED on the mikroprog light short and thats it.

On the board there is a STM32F103C8T6 MCU.

Has anyone a tip why this mcu was not identified?

Thanks for answers.

Regards

CS

User avatar
janko.kaljevic
Posts: 3565
Joined: 16 Jun 2011 13:48

Re: Problems with mikroProg for STM32

#2 Post by janko.kaljevic » 24 Dec 2012 15:07

Hello,

Please open Options menu in mirkoProg Suite for ARM.
Under Interface make sure that STLink and SWD are selected.

Best regards.

CS
Posts: 357
Joined: 20 Dec 2005 23:30
Location: Germany

Re: Problems with mikroProg for STM32

#3 Post by CS » 24 Dec 2012 17:47

Hello janko.kaljevic,

I can program the MCU in both ways JTAG and SWD but the programmer doesn't identify the MCU!?

Regards

CS

User avatar
janko.kaljevic
Posts: 3565
Joined: 16 Jun 2011 13:48

Re: Problems with mikroProg for STM32

#4 Post by janko.kaljevic » 25 Dec 2012 12:55

Hello,

After programming, in mikroprog Suite should identify your controller as STM32F1.
Can you confirm that.

Best regards.

CS
Posts: 357
Joined: 20 Dec 2005 23:30
Location: Germany

Re: Problems with mikroProg for STM32

#5 Post by CS » 25 Dec 2012 16:17

Hello,

maybe that the microProg Suite identify the MCU, but the microPorg Suite

doesn't show the identifieed MCU!?

Regards

CS

Post Reply

Return to “mikroProg™ programmer and debugger”