debug problem ?
debug problem ?
I use mikroc pro for arm for stm32f407vg discovery.I want to hardware debug. first I adjust view-project settings-I select debug and hardware then when I start debugger it says command not supported.How can I solve this problem.
- aleksa.jovanovic
- Posts: 526
- Joined: 30 Jun 2015 08:48
Re: debug problem ?
If you are using the programmer on board the discovery you can just program, not debug.
Only our mikroProg for STM can debug on our compiler.
Best regards,
ALeksa
Only our mikroProg for STM can debug on our compiler.
Best regards,
ALeksa
Re: debug problem ?
What will I do ? For doing hardware debug? it is very important for me ? I do this http://www.mikroe.com/download/eng/docu ... uction.htm
- aleksa.jovanovic
- Posts: 526
- Joined: 30 Jun 2015 08:48
Re: debug problem ?
Hi,
I apologize for the, oversight, the mikroProg Suite for ARM is compatible with the on-board programmer/debugger.
Could you please send me the screenshot of your settings and error?
Best regards,
Aleksa
I apologize for the, oversight, the mikroProg Suite for ARM is compatible with the on-board programmer/debugger.
Could you please send me the screenshot of your settings and error?
Best regards,
Aleksa
Re: debug problem ?
unfourtuanetly I cant screenshoot now but a windows come and there writes just " not supported command " ..
- aleksa.jovanovic
- Posts: 526
- Joined: 30 Jun 2015 08:48
Re: debug problem ?
Do you have the latest mikroProg suite?
Have you installed it and it's drivers as admin? (Right click > Run as Admin)
Best regards,
Aleksa
Have you installed it and it's drivers as admin? (Right click > Run as Admin)
Best regards,
Aleksa
Re: debug problem ?
I didnt do that when I try I will write here again thank you so much....