MikroElektronika Forum

Hi,

I've been designing with TFT software since it was put on the market, I don't know, and I'm not aware if there is a function or a param that can make a complete layer visible or not during run time. If there isn't this would save a lot of programming, and program memory.

Giulio

Hi Giulio,

Unfortunately currently there is not any option or function which can do that, because layers are not defined in code.

The explanation of that you can find on this post:
http://www.mikroe.com/forum/viewtopic.p ... up#p219541

Best regards,
Aleksandar