mechanical arm
Posted: 13 Nov 2015 22:07
I have an easypic v7 i am having a hard time writing a program that will 1. turn on electromagnet. 2. turn on motor 1 to lower the magnet.3 reverse motor 1 to raise magnet with can. 4. turn on motor 2 180 degrees. 5. turn motor 1 on to lower the can. 6. turn off the electromagnet. 7. reverse motor 1. 8. turn motor 2 on again 180 degrees. 9. repeat 5 times. if anyone can help me with the code i would greatly appreciate it. I know its alot to ask for but i am a student learning about microprocessors and have had no luck with any of the codes i have tried and project is due in a week.